BattBorg dual 5V output from 6-pin header?

Forums:

I was wondering if I can safely bridge the connectors under the 6-pin header and have dual 5V output available?

i.e. bridge pin 4 to pin 3 and pin 6 to pin 5 so I can power a RasPi in the usual way and have another 5V output to power a servo?

piborg's picture

Pins 1, 3, and 5 are not connected to anything on the BattBorg.

You should be able to bridge pins 3 to 4 and 5 to 6 to create another power connection for a servo.
You should also be able to solder a signal wire to pin 1 so that you can connect a single 3-pin cable to the servo if you wish.

If you do make this change then do not try and connect the modified BattBorg via a PicoBorg Reverse, otherwise you will connect 5v to the I2C lines which will likely damage the Raspberry Pi and the PicoBorg Reverse.

Subscribe to Comments for "BattBorg dual 5V output from 6-pin header?"