Submitted by adeibiza on Sat, 05/23/2020 - 12:05
i'll be using it on a pi zero but i have a couple of add ons that need 5v (a small relay & a few leds) but as this takes up both 5v pins how would i go about splitting the output so that i can have a jumper to a breadboard rail ?
piborg
Sat, 05/23/2020 - 21:40
Permalink
BattBorg 5V connections
Only one of the 5V pins needs to be connected between the BattBorg and the Raspberry Pi. This means you can connect just two wires (GND and a 5V), leaving the other 5V spare.
This will allow you to connect the other devices to the second 5V pin on the BattBorg, Raspberry Pi, or both :)
adeibiza
Sat, 05/23/2020 - 21:53
Permalink
fab, thanks ! :)
fab, thanks ! :)