reverse headers?

Submitted by pokuister on Wed, 08/28/2019 - 04:29

Forums:

Hi all,

If I soldered my GPIO pins to the bottom of my pi zero rather than the top (so I could stick them through the bottom of my pi zero case) can I also solder the female header of hte piborg+ to the top of the board (rather than the bottom) to allow me to use the piborg+ with this configuration of pins?

I.e pins 1 and 2 would be swapped, 3 and 4, etc.

piborg's picture

piborg

Wed, 08/28/2019 - 12:59

Yes, the TriBorg+ has the pins wired such that it can be fitted to a Raspberry Pi in any orientation. The other connectors on the TriBorg+ will be in the same layout as the connection to the Raspberry Pi.

Subscribe to Comments for "reverse headers?"