the light on my thunderborg motor controller suddenly stop showing and it does not rotate my motors, but it is powering my raspberry pi. I Need your assistance please.
The ThunderBorg turns on when it gets power on the 3V3 line from the Raspberry Pi. When this happens it cycles the LED through red, green, blue. After that it should go into power monitoring on the LED.
As the Raspberry Pi is getting power it sounds like the cable which has 3V3 and the I2C connections is not making good contact. Here are the connections: https://pinout.xyz/pinout/zeroborg
piborg
Sat, 03/23/2019 - 10:20
Permalink
ThunderBorg LED not working
The ThunderBorg turns on when it gets power on the 3V3 line from the Raspberry Pi. When this happens it cycles the LED through red, green, blue. After that it should go into power monitoring on the LED.
As the Raspberry Pi is getting power it sounds like the cable which has 3V3 and the I2C connections is not making good contact. Here are the connections: https://pinout.xyz/pinout/zeroborg