Two XLoBorgs

Forums:

I would like to run two XLoBorgs from the same Pi, one to be fixed to Diddy and the other fixed to a camera which rotates 360 degrees. Presumably I will need to change the i2c address on one of them?

I'm assuming that I can connect the one to be mounted on the camera to flexible leads, how many of the pins on the XLoBorg are used?

Thanks

piborg's picture

Unfortunately XLoBorg is one of the few boards we have that you cannot change the I2C address. This means you cannot connect two XLoBorgs to a single Pi at the same time :(

It is possible to connect an XLoBorg using cables though. The pins it needs are:

  1. 3V3
  2. SDA
  3. SCL
  4. Any GND

Ok, thanks. It'll have to plan B then :-)

Subscribe to Comments for "Two XLoBorgs"