Submitted by Manisha on Fri, 02/19/2016 - 16:53
Hello everybody,
I need help with connecting battery wires to soldered Battborg. The wires are not going inside and are very loose. Do I need to solder them in. Please any tips on it will be much appreciated.
Thanking you,
Manisha
piborg
Mon, 02/22/2016 - 11:23
Permalink
BattBorg screw terminals
You should not need to solder the cables to the terminals, the idea is the screws are used to clamp them in place.
You may need to untighten the screws so both of the slots are open before the wires will go in using a screw driver, turn them anti-clockwise to open them:
When they are open the wires should easily go into their slots.
Once in the slots you then need to tighten the screws by turnng them clockwise to close them.
When they feel like the are fully closed give the wires a gentle tug to ensure they do not come out.