connect BOTH a UltraBorg and a Picoborg Reverse

Submitted by batesm0t3l@outl... on Mon, 09/14/2015 - 20:50

Forums:

How can I connect BOTH a UltraBorg and a Picoborg Reverse to my Pi GPIO ?

piborg's picture

piborg

Tue, 09/15/2015 - 10:30

The simplest way to do this is to use the daisy-chain connector on one of the boards.

Simply connect the two 3-pin cables from one board to the Raspberry Pi, and from the second board to the daisy-chain connector on the second board.

For example:

  • Raspberry Pi GPIO → PicoBorg Reverse 6-pin header
  • PicoBorg Reverse daisy-chain connector → UltraBorg 6-pin header

Here are the connections on the PicoBorg Reverse.
The UltraBorg would be where the right-hand PicoBorg Reverse is.

Here are the same connections on the UltraBorg.
The PicoBorg Reverse would be where the left-hand UltraBorg is.

Subscribe to Comments for "connect BOTH a UltraBorg and a Picoborg Reverse"