Battborg
Forums:
Can I fit a triborg into a pibow rainbow box I want to fit a adafruit Screen or something similar fitted to pibow and also use battborg to power it from 8 AAs would it be better to put the screen into the pi then run the cables out the side of the screen then connect triborg using a ribbon and run jumpers to battborg would this work OK
piborg
Thu, 06/18/2015 - 14:43
Permalink
TriBorg and Pibow case
I do not believe that a TriBorg will fit directly inside a Pibow case, even without a screen attached.
Fitting a TriBorg onto the ribbon cable instead should work fine, you my need to plug the cable on to the top of the TriBorg instead if it has a connector with holes instead of pins.
You can happily attach the BattBorg to any of the TriBorg headers in the same way you would the Raspberry Pi GPIO header itself.